This bench cable can be used to reprogram the ACM in JCB engines.
Length: 1.5m
-
DCU17CV51 bench cable for New Trasdata
The VW UP GTI traction control switch allows you to disable traction control on the Volkswagen UP GTI. For cars that do not have this capability from the factory
Scania Continental EMS S8 Cable to OBD. Used to connect to ECUs without the risk of bending pins, and also saves a lot of time.Brak na magazynie
EDC17CV41 Bench Cable TRASDATA for use with flasher tool.Brak na magazynie
A set of cables for upa-usbSale!
KESS3 – John Deere Premium 9 pin round cable
Replacement cable used for reading DAF, MAN and SCANIA engine controllers.
Flat connection cable 35cm for FlexBox C port to NEC7 F00XX
Frame for reading drivers in "boot mode" and using the BDM connector.
The frame has LED backlight and dowels for Bosch controllers.
The frame has linear bearings, blockage of the carriage height.
Made in CNC technology, ensuring precise positioning, powder coated which makes it durable in long operation.
Can be extended with an additional rear shelf for the programmer.
SALE ! The successor of the X17 device allows reading the contents of the controller's memory both through the OBD connector, in the Bench and Boot modes. The basic function of the device is to read and write flash and eeprom memory, as well as full cloning of engine and transmission controllers. Ultimately, all protocols currently supported by the X17 module will be transferred.
All FCA vehicles after 2018 are equipped with a SGW security gateway module to prevent attacks on the vehicle's network via the CAN bus. Direct connection to the OBD II-16 connector does not always give the required results-you can read errors but not clear them, you cannot program the controllers as well as make adaptations/adjustments, etc. In the case of this problem, you can bypass the SGW (Security Gateway) using the presented adapter so that full communication functionality is available.Title
