-
Key programmer KEY MASTER 5 -
Autocom Charger (GYSFLASH) 12V 120A W071068002
CHARGER 12V Powerful and smooth unit for passenger cars and LCV. • Supports up to 120A. • For 12V lead or lithium batteries between 5 - 1500 Ah. • Low height (13 cm) allows the device to fit underneath a vehicle. -
Autocom Charger (GYSFLASH) 6-24V 100A W071068001
Autocom CHARGER 6-24V are high-power chargers with inverter technology. They maintain a stable voltage throughout the vehicle’s electrical systems. The voltage can be adjusted in order to meet the requirements of different vehicle manufacturers. CHARGER 6-24V Robust unit with a wide range of use for the entire vehicle fleet. • Supports up to 100A. • For 6, 12 or 24V lead or lithium batteries from 5 - 1200 Ah. • Cable reel on the front. • To be placed on a wall, a trolley or a vehicle lift -
Truck diagnostic cable with connection to the 16-pin Scania truck diagnostic system. COBD replacement for Alientech 144300K215 and Dimsport F32GN020. Length: (Approx) 2.5m -
Brak na magazynie
The JLR All Keys Lost wiring kit is essential in some cases during the key programming procedure when a direct connection to the CAN-BUS is required. The software automatically detects the platform on which the vehicle is based and prompts the customer when such a connection is required. The cable is connected between the AVDI and the OBDII cable. -
Brak na magazynie
Connection cable CB021 is used for the internal CAN connection when performing key procedures on Renault and Nissan vehicles. It can also be used for mileage recalibration and module replacement on selected Renault models. -
Brak na magazynie
Cable bench AutoTuner (VAG MG1CS002 - MG1CS008 - MG1CP007 - MG1CS047) ATUBA011
Supported ECUs:- Bosch MG1CS002
- Bosch MG1CS008
- Bosch MG1CP007
- Bosch MG1CS047
Cable bench AutoTuner for EDC16+ME(D)9 ATUC052
The orange universal cable is used in bench mode to connect the AutoTuner tool to the ECU’s plug without having to open it. Updated version also compatible with Denso Gen2 micro pins.
FLEX Bench cable for EDC17C60 ECU FLX2.67.
The FLX2.67 cable allows you to connect the Flex programmer to the EDC17C60 ECU. Specifically, the connection is established via the A and B ports of the FlexBox.
FLEX Bench cable for Continental M3C FLX2.69.
The FLX2.69 cable allows you to connect the Flex programmer to M3C engine control units. The connection is established via the Flexbox unit.
FLEX Bench cable for 8G Tronic VGS3-FDCT gearboxes FLX2.31.
This cable connects Flex to the 8G Tronic VGS3-FDCT automatic transmission unit. The connection is established via the F port of the Flexbox unit.
