-
Jaltest diagnostic cable Volvo Penta Diesel 6 PIN JDC527A The accessory cable for the Jaltest diagnostic tester allows connection to Volvo Penta Diesel engines equipped with a 6-pin connector Link version V8.1/V9 Length 28-30 cm -
Brak na magazynie
STANDARD OBDII CONNECTOR FOR EURO5 BIKES WITH 12V ADDITIONAL WIRE F32GN076 -
Cable for reading an engine control unit with DATA LINK STD connector (PERKINS/CATERPILLAR) -
Brak na magazynie
"The Bench Platform is a state-of-the-art tool for optimising service bench work in the vehicle electronics industry. It allows electronics to be held stably and securely during repair and programming, offering easy access to equipment. -
Brak na magazynie
New Genius Master Car/ LC- NEW GENIUS Hardware
- HASP Key
- Protocols activation : Car/LCV
-
Sale!
The subject of the sale is the FLEX Full Master FLK02.V02 device including additional connectors and cable with all available protocols in Master mode. The successor of the X17 device, it allows the reading of the contents of the drivers' memory both via the OBD connector, in Bench and Boot mode. The primary function of the device is to read and write flash and eeprom memory, as well as full cloning of engine and gearbox controllers. Ultimately, all protocols currently supported by the X17 module will be ported. The kit includes the following connectors: FLX4.2G: connectors for EMS3140, EMS3141, EMS3160, EMS3161, EMS3142 FLX4.2H: connectors for EDC17C49, EDC17C69, EDC7UC32, EDC7C1, EDC7C2, EDC7C3 FLX4.2I: connectors for MDG1 FLX4.2L: connectors for earthmoving machinery, trucks, agricultural machinery and construction vehicles, including Cummins CM2150C, Cummins CM2150E The kit also includes the FLX2.14 cable: manufactured by Magicmotorsport, it allows the Flexbox to connect directly to the vehicle's standard OBD port. This 44-pin connector accessory allows you to use the Flexbox touch button to select one of four available modes during bench programming and more. -
This cable allows you to connect to AdBlue ACM2.x control modules installed in Mercedes buses and trucks. Main features:- for ACM2.x modules
- safe connection
- minimal risk of error
-
BENCH TESTER is a device used for testing vehicle electronics.Modern electronic systems are activated in the vehicle with digital information on the CAN or LIN bus. When the ignition is turned on, electronic components, such as the meter (DASHBOARD) or power steering electronics (EPS), receive information on the CAN bus about the ignition (15) from one of the modules like GATEWAY or BCM.
So in order to turn on the tabletop removed electronics from the vehicle we need the right digital information, without it we have no way to start the electronics in question outside the car.
BENCH TESTER is a test platform with which we have the ability to connect and start the electronics outside the car.
BENCH TESTER is an interface that has the ability to connect any electronics used in motor vehicles.
-
Sale!
EDC7UC31 for use with the DFOX tool. Used for easily connecting to ECUs without the risk of bending pins, and also saves a lot of time and Time is money. -
for ECU:- MG1CS003
- MG1CS024
- MG1CS201
- MD1CS001
- MD1CP002
- MD1CP032
-
GODIAG GT100+ New Generation OBDII Break Out Box ECU Bench Connector with Electronic Current Display and CANBUS Protocol is the latest testing platform for OBDII protocol communication detection and ECU maintenance/ diagnosis/ programming/ coding.
-
Brak na magazynie
The probe is exclusively used for Bosch EDC17 ECUs. It is required when working in boot mode.
